Tools ( Timer, Counter & Totalizer ) - Chauvin Arnoux CA 650 Notice De Fonctionnement

Note:
Æ
To illustrate the difference between DisplayHi, DisplayLo and Scale Hi, Scale
Low. Here is a typical example, with input 0-10V, Scale Low=0.00, Scale
Hi=100.00, to have better resolution and vision on Bar, set DisplayLo=0.00,
DisplayHi=50.00 so that the Bar displays from value 0.00 to 50.00.
Æ
The decimal point is defined by Scale Hi and Scale Low, and not by
DisplayHi, or DisplayLo.
4.3. Tools ( Timer, Counter & Totalizer )
Press Back key, to return to the beginning of Configuration mode. Select Tools, then
press Enter key to get into Tools mode. Timer, Counter and Totalizer are defined here.
Counter and Totalizer are available only if the options of Math, Counter &
Totalizer have been selected.
Figure 4 – 5
84