Dometic COOLAIR SP950C Instructions De Montage page 8

Guarantee
Fit the fastening frame and the condenser unit at the lveco Stralis Hi-Way Euro 6 as
follows:
I
NOTE
Only install the condenser unit after you have attached the mounting
frame on the rear wall of the truck.
➤ Insert and tighten the four M8 x 35 (8.8) bolts, eight M8 8.4 x 16 mm U washers
and four M8 retaining nuts (fig. 1, page 3) in the mounting frame for the con-
denser unit.
➤ Remove the two M8 screws from the upper spoiler holder (fig. 2 1, page 4).
➤ Remove the two dummy plugs beneath the upper spoiler holder from the M8
drill holes.
➤ Fasten the upper part of the fastening frame on the upper spoiler holder with the
M8 x 40 (10.9) screws (fig. 2 1, page 4).
➤ Fasten the lower part of the fastening frame into the M8 drill holes now available
with the M8 x 35 (10.9) screws (fig. 2 2, page 4).
➤ Put the the four large M8 8.4 x 24 mm U washers as spacer discs onto the pro-
truding screws on the fastening frame (fig. 2 2, page 4).
➤ Place the condenser unit on the projecting bolts of the mounting frame and bolt
to the four U washers M8 8.4 x 16 mm and four M8 retaining nuts (fig. 3,
page 5).
➤ Check that all bolts are still tight after travelling approximately 200 km.
6 Guarantee
The statutory warranty period applies. If the product is defective, please contact the
service partner in your country (addresses on the back on the instruction manual).
Our experts will be happy to help you and will discuss the warranty process with you
in more detail.
8
CoolAir SP950C, SPX1200C
EN