Maico PP 45 O Notice D'utilisation page 64

11 Filter changes, unit cleaning
20 Slide-in module
33 Internal cover of fluid distributor
34 Centring ring
3. Pull the complete slide-in module out of the
wall sleeve. Also pull the pipe extension all the
way out.
4. Use a vacuum cleaner to clean the slide-in
module while still assembled.
5. If very dirty, disassemble the slide-in module.
20 Slide-in module
21.1 Ceramic heat exchanger
33.1 Screws
To do this, remove the 4 screws of the fluid dis-
tributor internal cover, take out profile seal and re-
move ceramic heat exchanger.
64
21.2 Ceramic heat exchanger
22 Profile seal
23 Fluid distributor slide-in module
Then remove fluid distributor slide-in module (4
plastic rivets →Cleaning PP 45 ventilation unit
[} 62]) and pull fluid distributor out of the slide-in
module. Take out profile seal and remove
ceramic heat exchanger. Rinse out both heat ex-
changers with water and leave to dry.
6. Assemble the slide-in module in reverse order.
Only insert a dry heat exchanger.
20 Slide-in module
23 Fluid distributor slide-in module
23.1 Sealing strip
33 Internal cover of fluid distributor
34 Centring ring
35 Pipe extension
NOTICE Damage to brickwork caused by con-
densation if sealing strip on fluid distributor
slide-in module and at end of extension is in-
correctly glued/is not sealed and the entire
unit is not slid in up to the stop.
Before installing, ensure that the sealing bands
are flush at the face end (face against face), are
not one on top of the other and are not overlap-
ping.