Torch Connection - ESAB PowerCut 700 Manuel D'instructions

US
5.5

Torch connection

For fast and easy separation of the torch from the power supply, the Power Cut 700
is equipped with a unique quick disconnect system.
Before connecting or disconnecting the torch, please keep these safety rules in
mind.
S
If the connector is loose or damaged, do no operate the system until it has been
repaired by a qualified professional. Always make sure that the connection is
tight and properly locked in place.
S
Never, under any circumstances, disconnect the torch while the equipment is on.
The system should be unplugged or otherwise disconnected from power prior to
servicing.
S
Never pull the power supply by its cables, or do anything that might damage the
cable or connector. The connector is designed to withstand wear from regular
use, but excessive abuse can render the connector unusable.
S
Like the power supply itself, the connector should never be operated in or near
standing water. Additionally, if the connector's silicon moisture seal is absent or
damaged, do not operate the system.
S
The gas connection is lubricated to ensure a smooth connection, but the
electrical connector should never be lubricated. Make sure to keep the electrical
connections clean and dry.
bp23aa
- 13 -
© ESAB AB 2012