Ordering Spare Parts - ESAB PowerCut 700 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

US
Problem
The pilot is working but there is
not sufficient current for cutting.
The cut is not perpendicular.
9

ORDERING SPARE PARTS

Repair and electrical work should be performed by an authorized ESAB service
personnel. Use only ESAB original replacement and wear parts.
PowerCut 700 is designed and tested in accordance with the international and Europe­
an standards IEC 60974-1, . It is the obligation of the service unit which has carried
out the service or repair work to make sure that the product still conforms to the said
standard.
When ordering replacement parts, order by part number and part name, as
illustrated on the figure. Always provide the series or serial number on the unit on
which the parts will be used. The serial number is stamped on the rating plate.
To ensure proper operation, it is recommended that only genuine ESAB parts and
products be used with this equipment. The use of non-ESAB parts may void your
warranty.
Replacement parts may be ordered from your ESAB Distributor
Be sure to indicate any special shipping instructions when ordering replacement
parts.
Refer to the Communication Guide located on the last page of this manual for a list
of customer service phone numbers.
bp23aa
Cause
S
Bad contact of the earth
clamp
S
Bad connection of the
positive pole at the torch
cable
S
Worn electrode or nozzle
- 24 -
Solution
S
Check that the earth clamp
has a good contact with
the piece to be cut.
S
Check the connection of
the positive pole at output
to the socket, even on the
inside.
S
Replace the electrode and
the nozzle.
© ESAB AB 2012

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pt-39Powercut 400 pt-39

Table des Matières