Re-Fitting The Pt-31Xlpc Torch; Torch Connections; Strain Relief - ESAB Powercut 650 Manuel D'instructions

SECtIoN 5
5.5

rE-fIttINg tHE Pt-31xlPC torCH

1. For operator safety, the torch connections are located on the output terminal
board behind the lower portion of the front panel.
2. Thread the power cable and switch lead of the PT-31XLPC through the Strain
Relief on the Access Cover. Connect power cable to the torch fitting (left-hand
threads) and plug in the switch lead to the torch switch receptacle on the output
terminal board. Make sure the power cable connection is wrench-tight. Make
sure plug of switch lead is firmly locked in place.
3. Reassemble the access door to the power source. Retighten Strain Relief to secure
power cable, but do not overtighten.
WORK CLAMP & CABLE
ASSEMBLY
TORCH TRIGGER LEAD CON-
NECTION
figure 5-6. Pt-31xlPC torch Connections
123
MAINtENANCE
ACCESS COVER FOR

TORCH CONNECTIONS

STRAIN RELIEF

TORCH POWER CABLE CONNEC-
TION
PT-31XLPC
Plasma Cutting
Torch