2.2.2. V battery supply
2.2.2.1. General
Specifications
Location
Connections
Replacement
Procedure
2.2.2.2. Installation
Step 1
Dismantle the cover
using a crosshead
screwdriver.
Step 2 Disconnect and remove the accumulator pack.
34
www.electronicaembajadores.com
Batteries
two 9 V alkaline batteries, type 6LF22
Housing in the rear of the instrument
parallel
The symbol "BAT" will appear if the battery voltage is too low.
The 2 batteries must be changed.
1. Disconnect the test leads for the measuring circuits and
input.
2. Set the switch to "O".
3. Install as shown below.
Chapter II
Digital Earth Tester