Power Supply; Supply Via An Accumulator Pack (Reminder: Ca Model Ref. Hx0086) - Metrix MX 435D Notice De Fonctionnement

Chapter II
2.2.

Power supply

The equipment is supplied by power:
•
either from a rechargeable accumulator pack, CA model ref. HX0086,
•
or from 2 alkaline batteries.

2.2.1. Supply via an accumulator pack (reminder: CA model ref. HX0086)

2.2.1. General
Specifications
Location
Connections
Recharging
Procedure
2.2.1.2. Installation
Step 1
Fit the connection bar in
place, starting with the
right side.
Digital Earth Tester
www.electronicaembajadores.com
Accumulator pack
8.4V Ni-MH - 750 mAh
Housed in the back of the equipment (instead of the two 9 V
batteries)
to the connector, in the housing
The symbol "BAT" will appear if voltage is too low. The
accumulator pack must then be recharged (see paragraph
2.2.1.3.).
It is recommended to wait until the complete discharge of the
accumulator pack to prevent the early aging of the accumulator
pack.
1. Disconnect the test leads for the measuring circuits and
input.
2. Set the switch to "O".
31