Rcd Range Lights; Buzzer; Digital Display; Input Terminals - Metrix MX 435D Notice De Fonctionnement

2.1.5. RCD range lights

• The scrolling of the 5 RCD gauges (number 16) shows that the automatic shutdown is
imminent.
• In RCD measurements, a light shows the range selected to carry out the test
(30, 100, 300, 500 or 650 mA) and a flashing light shows why the test was interrupted
(see paragraph 3.7, p. 41).

2.1.6. Buzzer

In continuity mode, the buzzer sounding indicates that the value of the resistance measured
is less than 2 Ω.

2.1.7. Digital display

The display provides easy-to-read figures (12.7 mm high), comprising 3 ½ 7-segment digits
(2,000 points), with or without a decimal separator, depending on the chosen range (e.g.
20.00 or 2000).

2.1.8. Input terminals

7 input terminals:
• 1 COM/E/PE terminal:
• 1 Ω terminal:
• 1 V
terminal:
AC
• 2 MΩ terminals:
• 2 S and H terminals:

2.1.9. Stand

The retractable stand on the back of the instrument tilts the front panel for greater comfort
of use on a table.

2.1.10. Mains connector unit and assembly

This unit will be connected to and entirely cover the terminal. This unit acts as phase/neutral
fool proofing and can be used for RCD and R loop measurements:
2.1.11. 12 V mains power supply
This unit recharges the accumulator pack. A complete charge takes approximately 2 hours.
30
www.electronicaembajadores.com
entry of the low point of the measurement common to
voltmeter, ammeter, RCD test, continuity ohmmeter and earth
continuity
voltage or current
insulation
earth measurements
Chapter II
Digital Earth Tester