Nb08Pt-18 Troubleshooting Guide - Stanley NB08PT-18 Manuel D'instructions

9. NB08PT-18 TROUBLESHOOTING GUIDE

WARNING: Read instruction manual for tool itself together to understand the troubleshooting of tool.
Faulty Causes
Power does not turn 1. Battery is not fully attached.
ON
2. Battery is not fully charged.
3. Battery is malfunction.
4. Trigger module malfunction.
Screen freezes at 1. Data reading error.
Stanley Engineered
Fastening Logo
2. Smart screen malfunction.
3. Trigger module malfunction.
4. Setting data are broken.
Tool do not function 1. Screen is not home screen
when mandrel was (Counter screen).
push
2. Screen malfunction, freezing or all
white.
3. Alarm message is shown with beep
sound.
4. Setting data are broken.
5. Radio communication error.
6. If tool is already operating
Tool does not operate 1. Screen is not home screen
when trigger switch is (Counter screen).
pressed.
2. Screen malfunction, freezing or all
white.
3. Not in operating
Insufficient or excessive 1. Inappropriate setting value of
fastening stroke. fastening stroke or fastening load
2. Malfunction of control part.
3. Setting file is malfunction.
4. Trigger module or screen module
malfunction.
Stroke and Force value 1. Value setting cannot be selected
setting cannot change
2. Wrong password
Tool does not count 1. Fastening force is too low.
correctly (does not
count or counts even if
it does not set nut).
2. Battery is not fully charge.
3. Battery is malfunction.
4. Setting files are malfunction.
5. Calibration abnormal
Assumed fully charge 1. Battery is not fully charge.
battery fasterned low
number of nuts.
2. Battery is malfunction.
Solutions
Remove battery and re-insert. Reset
tool to home.
Charge battery.
Replace battery.
Contact a local service centre.
Remove battery and reinsert. Press
trigger to turn ON.
Contact a local service centre.
Contact a local service centre.
Restore to factory setting.
Get screen to home scrren. Touch
"Back home" icon to be back home.
Remove battery and reinsert. Press
trigger to turn ON. Or set the tool to
default. If not solve, contact a local
service centre.
Reset alarm refering to the related
pages.
Restore to factory setting.
Restore to factory setting. If not slove,
contact local service centre.
Continue with fastening or enforced
spin off
Get screen to home scrren. Touch
"Back home" icon to be back home.
Remove battery and reinsert. Press
trigger to turn ON. Or set the tool to
default. If not solve, contact a local
service centre.
Get the tool to operate
Please use appropriate setting value
Set up to factory default condition. If it
does not return,contact a local service
centre.
Restore to factory setting.
Contact a local service centre.
Select the value setting method
correctly.
Default password: 2000
Reset stroke and force.
For aluminum M3 at extremely low
force, it cannot count in some cases.
Check battery charge level and charge
battery if low.
Replace battery
Restore to factory setting.
Contact a local service centre.
Check the battery level and fully
charge the battery.
If power consumtion is faster than
usual, replace battery.
35
E N G L I S H
Page
Refer tool manual
Refer tool manual
-
-
-
-
-
27
10
27
Each
27
-
26
10
27
-
15, 16, 17
-
27
-
15
15
9
26
-
-
31
26
-