Operation; Before Using Your Grinder; Duty Cycle; Hopper Installation - Baratza SETTE 30 Manuel

Masquer les pouces Voir aussi pour SETTE 30:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
5
SETTE™ 30 MANUAL
®

OPERATION

BEFORE USING YOUR GRINDER

Prior to using your Sette grinder for the first time, you should wash the bean hopper and grounds bin in warm soapy water.
Do not wash the grind adjustment assembly or burr. See the section on Care and Cleaning for instruction on how
to remove and reinstall these parts. Place the Sette on a level surface and plug the power cord into the back port on the
machine. Plug the cord into a correct voltage AC outlet only. There may be some rust on the burrs when you receive your
grinder. This is normal and will disappear after a small amount of coffee has been ground. To remove the rust and season
the burrs, grind a handful of beans (~40g) on setting 15 and discard. This begins the burr seasoning process and primes
the grinder for normal operation.

DUTY CYCLE

The Sette was designed for a maximum of 2 lbs (1 kg) per day, with an espresso duty cycle of 10%. We want to remind
everyone buying the Sette grinder that it was designed for home use (short duration grinding).
Here is a general overview of the duty cycle of the Sette Series:
Espresso (Setting ~10) it will take about 6 seconds to grind a dose of espresso, then the grinder should rest for 60
seconds. This is about what you could do if making back-to-back shots on a one-group machine.
Brew (Setting ~25) it will take 5 to 30 seconds to grind up to 150 grams of coffee, then the grinder should rest for 60
seconds. Remember, a maximum of 150 grams at one time, with a 1 minute off before grinding again.
The duty cycles described above will work great for home brewing. If you choose to use it in a commercial situation, please
think about the Sette's duty cycle function and decide if this will be a successful choice for your bar setup.

HOPPER INSTALLATION

With the hopper lid in place, mount the hopper by lining up the hopper's bean shutoff knob at the 11:00 position (back left).
Press the hopper down, and rotate clockwise until the alignment tabs on the front are aligned. Flip the bean shutoff knob to
the "open" position and pour in desired quantity of roasted, whole coffee beans.
May 2019 (v3)

Publicité

Table des Matières
loading

Table des Matières