Pairing Management; Clear Pairings - oticon EduMic Mode D'emploi

Pairing management

To listen to the streamed signal from EduMic, the hearing aids should be in the
EduMic program. This can happen automatically or manually.
Automatic hearing aid program change
EduMic can store up to 10 sets of hearing aid pairings. When any of these sets of
hearing aids are within a 20 m range of EduMic, they will automatically change to
the EduMic program. By muting and unmuting EduMic, you also initiate a program
change in the hearing aids.
Manual hearing aid program change
When EduMic is paired with more than 10 sets of hearing aids, not all of the
pairings are stored in EduMic. In this case, the hearing aid user can manually
change to the EduMic program on their hearing aids or alternatively, on a
personal remote control.
IMPORTANT NOTICE
Please refer to the hearing aid's instructions for use for details on the functionality of
the specific hearing aid.
24 About Start-up Handling Other modes Warnings More info

Clear pairings

It is possible to clear all pairings from EduMic when these are no longer needed.
Pairing the hearing aids again will ensure access to automatic program change
for these hearing aids.
Ensure EduMic is turned ON Clear pairings
Press and hold down the button for
12 seconds until the status indicator
turns RED.
All pairings with hearing aids are now
cleared from EduMic.
25