Product Description; Features Of The Appliance; Installation; General Preparation - Dovre Sonata Installation Et Mode D'emploi

material.
The rule of thumb for a single-walled tube is a
distance of 3x the diameter. If a lining shell is
fitted around the tube, a distance of 1x the
diameter is permissible.
Carpets and rugs must be at least 80 cm away
from the fire.
Use a fireproof floor plate to protect a
flammable floor from any ash which may fall in
front of the stove. The protective plate must
comply with national standards.
For the dimensions of the fireproof protective
plate: see the appendix "Distance from
combustible material".
For further requirements in connection with fire
safety: see the appendix "Distance from
combustible material".

Product description

6
1. Bottom of the fire compartment
2. Door
3. Door latch
4. Primary air slide
5. Secondary air slide

Features of the appliance

The appliance is an entirely cast-iron design with
modern combustion technology.
The combustion chamber is protected by
vermiculite inner plates.
The door (2) closes the stove hermetically, ensures
for well-functioning air control and protects against
fire hazard.
The appliance is supplied with the door latch (3)
installed. As the door latch becomes warm during
use, a glove has been supplied to protect your
hand.
The top plate lies loosely on the appliance.
Wood is burned on the base plate (1) and the
remaining ashes can be removed via the ash
removal port. Ash is collected in an ash pan. The
ash pan can be found behind the door.
The stove has two air controls, a primary air slide
(4) and a secondary air slide (5).
The appliance is provided with side glass panes for
a better view of the fire.
The appliance is suitable for connection to outside
air supply. The appliance comes standard with a
connection kit necessary for this.

Installation

General preparation

Please check the appliance immediately after
delivery for damage caused during transport or any
other damage or defects. The appliance is attached
to the pallet with screws at the bottom; see
following figure.
Subject to change because of technical improvements