Hdmi; Important Information Regarding The; Hdmi Connection; Configuration - Pioneer SX-319V Mode D'emploi

Additional information

HDMI

Symptom
No picture or sound.
No picture.
No sound, or sound
suddenly ceases.
Important information regarding
the HDMI connection
There are cases where you may not be able to
route HDMI signals through this receiver (this
depends on the HDMI equipped component you
are connecting-check with the manufacturer for
HDMI compatibility information).
If you aren't receiving HDMI signals properly
through this receiver (from your component),
please try the following configuration when
connecting up.
Note
•
1 If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.
•
Depending on the component, audio output may be limited to the number of channels available from the connected display
unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).
•
If you want to switch the input source, you'll have to switch functions on both the receiver and your display unit.
•
Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every
time you switch input sources.
Remedy
• If the problem still persists when connecting your HDMI component
directly to your monitor, please consult the component or monitor manual
or contact the manufacturer for support.
• Depending in the output settings of the source component, it may be
outputting a video format that can't be displayed. Change the output
settings of the source, or connect using the component or composite jacks.
• This receiver is HDCP-compatible. Check that the components you are
connecting are also HDCP-compatible. If they are not, please connect
them using the component or composite video jacks.
• Depending on the connected source component, it's possible that it
will not work with this receiver (even if it is HDCP-compatible). In this
case, connect using the component or composite video jacks between
source and receiver.
• If video images do not appear on your TV or flat panel TV, try adjusting
the resolution, Deep Color or other setting for your component.
• To output signals in Deep Color, use an HDMI cable (High Speed HDMI
Cable) to connect this receiver to a component or TV with the Deep Color
feature.
• Check the audio output settings of the source component.
• Check that the Audio Parameter setting is set to HDMI AMP/THRU
(refer to page 28).
• If the component is a DVI device, use a separate connection for the audio.
1

Configuration

Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
10
TM
39
En