Table des Matières
Publicité
1
General information about the non-automatic weighing instrument
All properties of the non-automatic weighing instrument, whether mentioned or not, shall not be in
conflict with the legislation.
This certificate contains references to other certificates. The properties mentioned in these
certificates shall be observed in addition to the properties mentioned in this certificate.
1.1
Essential parts
Indicator / analog data processing device / terminal:
Producer
Minebea Intec GmbH
Minebea Intec Bovenden
GmbH & Co. KG
Minebea Intec Bovenden
GmbH & Co. KG
Minebea Intec Bovenden
GmbH & Co. KG
Minebea Intec GmbH
Minebea Intec GmbH
Minebea Intec GmbH
-
-
Any load cell(s) may be used under this certificate for instruments as described in WELMEC 2.4
Issue 2, provided the following conditions are met:
There is a respective certificate (EN45501) or an OIML Certificate of Conformity (R 60) issued for
the load cell by a Notified Body responsible for type examination under Directive 2014/31/EU.
-
The certificate contains the load cell types and the necessary load cell data required for the
manufacturer's declaration of compatibility of modules (WELMEC 2, 2015 clause 10), and any
particular installation requirements. A load cell marked NH is allowed only if humidity testing to
-
EN45501 has been conducted on this load cell.
The compatibility of load cells and indicator is established by the manufacturer by means of the
compatibility of modules form, contained in the above WELMEC 2 document, at the time of
putting into use.
The load transmission must conform to one of the examples shown in WELMEC 2.4 Issue 2.
Type
PR5410
TA
TM...
TA-X
PR5230 with PR5110
PR5900
PR5500
D e s c r i p t i o n
Number T11379 revision 0
Project number 1902516
Page 1 of 3
Certificate number
D09-07.54
D09-11.02
D09-07.21
DE-15-EC-PTB002
TC7959
DE-15-PC-PTB005
DE-18-PC-PTB002
Certificat
Midrics 1/2
105
Publicité
Table des Matières
