Description; Correct Use - Hilti WSR 650-A Mode D'emploi

2. Description

The WSR 650-A is a cordless reciprocating saw for
professional use. The tool is suitable for use by right
or left-handed persons. The ergonomically designed
rubber-padded grip reduces fatigue and is designed to
provide a secure hold.
en
The items supplied include:
– Cordless reciprocating saw and saw blade
– Operating instructions
– Toolbox

2.1 Correct use

Typical working environments include rescue services,
general construction, renovation and conversion work,
metal construction, plumbing / heating / air-condi-
tioning installation trades, in workshops and on con-
struction sites, public authorities, farming and forestry.
The tool is designed to cut wood, wood-like materials,
metals and plastics.
The tool is designed for two-handed operation.
●
Use only the blades and accessories listed in the
●
operating instructions.
Do not use the tool in a damp environment.
●
Do not use the tool in environments where there is
●
a risk of explosion.
The tool may be powered only by the batteries approved
●
for use with this tool.
Do not use the batteries as a power source for oth-
●
er equipment.
Use only the recommended battery charger.
●
Use of a pipe-cutting adaptor with the tool is not per-
●
missible.
Do not cut bricks, concrete, cellular concrete, nat-
●
ural stone or tiles.
Do not use the tool to cut pipes that still contain
●
liquids.
Do not cut into unknown materials.
●
Use the tool within its intended cutting performance
●
range and with suitable blades (do not use blades of
the wrong size or reciprocating saw blades not
equipped with a
Cutting materials containing asbestos is not per-
●
missible.
The tool is intended for professional use.
●
The tool may be operated, serviced and repaired only
●
by authorized, trained personnel. This personnel
must be informed of any special hazards that may
be encountered.
The tool and its ancillary equipment may present
●
hazards when used incorrectly by untrained per-
sonnel or when used not as directed.
12
Printed: 07.07.2013 | Doc-Nr: PUB / 5071406 / 000 / 00
" connection end).
1 /
2
-WARNING-
Before cutting pipes, always first ensure that the pipes
contain no liquids. Empty the pipes if necessary. The
tool is not water or moisture proof. Liquids running
out may cause a short circuit in the tool resulting in an
electric shock being received. When cutting pipes, hold
the tool so that it is higher than the pipe being cut.