Safety Information - HYDAC ELECTRONIC HLT 1100-R2 CAN Notice D'utilisation

HLT 1100-R2 CAN Mod. 000

2.8 Safety information

 Destruction, damage or malfunctions of the measuring system !
Wiring work or opening and closing electrical connections must be
-
carried out in de-energized condition only.
Do not carry out welding if the measuring system has already been
-
WARNING !
wired up or is switched on.
Ensure that the area around the assembly site is protected from
-
corrosive media (acid, etc.).
Avoid any shocks (e.g. hammer-blow) on the measuring system
-
while mounting.
Do not bend the sensor rod
-
CAUTION !
Do not install the measuring system next to magnetic fields.
-
Do not open the measuring system.
-
The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by improper use.
Touching the measuring system connection contacts with bare fingers
-
must be avoided, resp. the appropriate ESD protective measures are
applicable.
 Disposal
If disposal has to be undertaken at the end of a device's lifespan, the
respective applicable country-specific regulations must be taken into
consideration.
 Device designs
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here and in
the interface-specific user manuals.
The technical details for customer-specific device designs, including
connection technology, may differ from the designs described here and in
the interface-specific user manuals. In case of doubt, the manufacturer
should be consulted, specifying the item number.
Status: 2021/04/22 HYDAC ELECTRONIC GMBH
9
E
Part No.: 669937