HYDAC ELECTRONIC HLT 1100-R2 CAN Notice D'utilisation page 32

12
The sealing of the sensor inside the cylinder is done by an O-ring, which is ready
installed on the sensor housing.
The securing of the sensor inside the cylinder is carried out by means of a M5 threaded
pin according DIN 913 or DIN 914. The maximum torque of 0.5 Nm should not be
exceeded.
Assembly from rod direction:
E
Assembly from head direction:
Status: 2021/04/22 HYDAC ELECTRONIC GMBH
HLT 1100-R2 CAN Mod. 000
Part No.: 669937