Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig./Abb./ Рис 19
Fuses: Replacement
Fig. 20
Fig./Abb./ Рис 20
Fig./Abb./ Рис 20
To replace the fuses in the control panel of the machine, proceed as follows:
•
Stop the machine and press the emergency button (fig. 8, ref. 2); engage the parking brake by means of the pedal (fig. 8, ref. 12);
•
Remove the fuse cover (fig. 20, ref. 1);
•
With the tweezers supplied with the machine take out the blown fuses and replace them with new ones of the same amperage;
•
Reclose the fuse cover.
The fuse FU7 must NOT be fitted if the machine is provided with gel batteries.
To replace the fuses inside the electrical box, proceed as follows:
•
Stop the machine and press the emergency button (fig. 8, ref. 2); engage the parking brake by means of the pedal (fig. 8, ref. 12);
•
Remove the bonnet (fig. 2, ref. 4);
•
Remove the cover of the electrical box (fig. 21, ref. 1);
•
With the tweezers supplied with the machine take out the blown fuses and replace them with new ones of the same amperage;
•
Re-close the cover of the electrical box;
•
Refit the bonnet.
FUSE DESCRIPTIOn
FU1
General fuse of power
FU4
Suction motor fuse
FU5
Control protection fuse
FU6
Brush electronic control switch
FU7
Switch for gel batteries
FU8
Solenoid valve control switch
Fuse chart: for a chart of the fuses see the parts list.
Never fit a fuse with a higher Amp value than the intended one.
If a fuse keeps burning, it is necessary to identify and repair the damages present in the wiring, boards (if fitted) or motors: have the
machine checked by trained technical staff.
Periodic Maintenance
Daily Maintenance
Every day at the end of work perform the following operations:
•
Stop the machine and press the emergency button (fig. 8, ref. 2);
•
Engage the parking brake by means of the pedal (fig. 8, ref. 12);
•
Empty the recovery tank and clean it, if necessary;
18
Fig./Abb./ Рис 19
Fig. 21
Fig./Abb./ Рис 21
Fig./Abb./ Рис 21
Publicité
Table des Matières
