Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Screw again the cap on the recovery tank.
Squeegee Blades: Check And Replacement
The blades of the squeegee are used to scrub from the floor the film of water and detergent thus allowing a perfect drying. As long
as time goes by the continuous scraping rounds off and splits the sharp edge in contact with the floor, thus reducing the drying
efficacy and therefore requiring the replacement of the blades. Therefore, often check their state of wear and tear.
Exchanging or replacing the blades:
•
Stop the machine and press the emergency button (fig. 8, ref. 2); engage the parking brake by means of the pedal (fig. 8, ref. 12);
•
Lower the squeegee by using the proper lever (fig. 8, ref. 11);
•
Take off the squeegee (fig. 2, ref. 8) from its supporting plate (fig. 9, ref. 2) by unscrewing completely the two knobs (fig. 9, ref. 3);
•
Slide out the sleeve of the suction tube (fig. 9, ref. 4) from the squeegee.
Fig 18
Fig./Abb./ Рис 18
Front blade:
•
Unscrew the knobs (fig. 19, ref. 1);
•
Remove the blade clamps (fig. 19, ref. 3);
•
Take out the blade (fig. 19, ref. 4);
•
Fit in the same blade inverting the edge in contact with the floor until all the four edges are worn, or else fit in a new blade;
•
Put the blade clamp (fig. 19, ref. 3) back;
•
Screw down all the knobs (fig. 19, ref. 1).
Rear blade:
•
Unhook the hook clamp (fig. 19, rif. 8);
•
Slide out the two blade clamps (fig. 19, ref. 7) by first pushing them outwards with respect to the squeegee unit (fig. 19, ref. 5)
and then taking them out;
•
Remove the blade (fig. 19, ref. 6);
•
Fit in the same blade inverting the edge in contact with the floor until all the four edges are worn, or else fit in a new blade
embedding it in the screws of the squeegee unit (fig. 19, ref. 5);
•
Put the two blade clamps (fig. 19, ref. 7) back, centering the largest part of the slots on the fixing screws of the squeegee unit
(fig. 19, ref. 5) and then pushing the blade clamps towards the inside of the squeegee itself;
•
Hook the clamp (fig. 19, ref. 8) again. Insert the squeegee back on its support following the instructions reported in §6.2.
Fig./Abb./ Рис 17
Fig. 19
Fig./Abb./ Рис 19
Fig./Abb./ Рис 20
Fig./Abb./ Рис 18
Fig./Abb./ Рис 21
17
Publicité
Table des Matières
