Fuses: Replacing - Dustbane Hurricane 400 Manuel D'opération

Fuses: replacing

! WARNING: Never use a fuse with a higher amperage than specified.
The fuses can only be replaced by a Dustbane service centre or by technical personnel authorized by Dustbane.
The fuses protecting the brush and suction motors are located in the fuse holder (ref. 1) attached to the recovery tank above the
machine battery compartment.
To replace the fuses:
• Make sure the dirty water drum is empty and empty if necessary;
• Raise the dirty water drum;
• Raise the fuse holder cover and remove the fuse by unscrewing the fixing screws;
• Fit a new fuse and close the fuse holder cover;
• Lower the dirty water drum.
• Fuse table: For the complete fuse table, see the spare parts catalogue.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be identified and repaired. Have the machine
checked by qualified personnel.
16
Operations Manual
Fig./Abb./
Hurricane 400 XTT / Hurricane 400 XTT – Traction
Fig./Abb./ 12
图
13
图
Fig./Abb./
Fig./Abb./ 14
图
15
图
A