Dustbane Hurricane 700 XTT Manuel D'opération page 23

The battery-charger has not been installed correctly.
The battery-charger does not work.
After recharging with an electronic battery-charger the storage-battery does not show the correct voltage (about
2,14v for each empty element) and only one or few elements turn out to be flat when tested with densimeter.
One or more elements are damaged.
The electrolyte that is present in the storage battery has a cloudy colour.
The storage battery has completed the charge/discharge cycles
indicated by the manufacturer.
The storage battery has been recharged with a too high current. Replace the storage battery.
The storage battery has been charged beyond the limit
suggested by the manufacturer.
CAUSE
CAUSE
Taking into account the actual voltage available at the socket,
check that the connections of the transformer primary circuit in
the battery-charger are correct (at this purpose read the manual
to the batterycharger).
Check that there is voltage at the battery-charger, that the fuses
are not interrupted and that there is current at the storage
battery; in addition try to charge by means of another rectifier:
if the battery-charger does not work, call the after-sales service
staff communicating the serial number of the battery-charger.
PROBLEM:
Replace, if possible, the damaged elements. For monoblock
storage batteries at 6V or 12V, replace the whole storage battery.
PROBLEM:
Replace the storage battery.
Replace the storage battery.
SOLUTION
SOLUTION
23