Zero Setting Of The Rear Derailleur - CAMPAGNOLO SUPER RECORD EPS Mode D'emploi

• The chain moves down from one sprocket (X) to the next (Y) with difficulty: the
position must be set to the sprocket (Y) and the "SINGLE SPROCKET" setting proce-
dure performed, shifting the position of the rear derailleur outwards (operating lever
C - Fig. 2 / right-hand control).
Note
The system shifts the position by a fixed increment of approximately 0.2 mm each time
lever B or C is pressed (Fig. 2).
To store the new setting, press the MODE button on the Ergopower EPS controls
briefly (D - Fig. 2).
At this point, the interface LED flashes 3 times and then turns off.
IMPORTANT!
If you do not press the MODE key briefly, which allows to complete the setting
procedure, the system will automatically exit the procedure after 48 seconds and
will save the new setting.
Every time a resetting to zero is conducted, previous adjustments are reset.

5.2 - ZERO SETTING OF THE REAR DERAILLEUR

WARNING!
Resetting the rear derailleur to zero is a particularly delicate operation and must
be carried out when the bicycle is stationary and placed on a stand. This is why
it should be conducted only and exclusively by a Campagnolo Service Center, a
Campagnolo Pro-Shop or a mechanic specialised in mounting EPS groupsets.
36 ENGLISH