Mettler Toledo Compact Antistatic Kit Mode D'emploi page 10

4.2.2 Installing second Antistatic Kit
Note : For the installation of a second Antistatic Kit you will also need a second AC adapter, see
Accessories (page 11).
1 Remove the relevant side door (1).
2 Remove the any of the 3 clips, for example
the middle one (2).
– Push the compact ionizer in from back to
front until it clicks into place. If necessary,
gently squeeze the strips at the back.
1 Insert the side door (3) marked with "Con­
ducting Glass" (4) at an angle of approx.
30° into the two slots.
2 Lift the side door against the balance until it
clicks into place.
3 Push the side door completely to the front.
4 Check that the side door runs easily, other­
wise it is not correctly inserted.
5 For XPE balances, return the handle to the
upright position.
For XSE balances, clip the handle together.
1 Plug the control cable (5) into Aux 1 or
Aux 2.
2 Plug the power supply cable (6) into the ion­
izer.
3 Connect the second AC adapter (7) to the
power supply.
6 Installation and Putting into Operation
2 1
3
4
5
6
7