Mettler Toledo Compact Antistatic Kit Mode D'emploi page 13

6 Maintenance
6.1 Cleaning
Clean the ionizer with a soft brush or with ethyl alcohol and a lint-free cloth.
Quick cleaning
Clean the ionizer once a month.
1 Clean the insulation, white PTFE, around the emitter pin (1) and the emitter pin itself.
Note : Avoid touching this area with fingers to prevent contamination.
PTFE is white again.
2 Check that no ethyl alcohol is left on the ionizer.
Cleaning
Clean the ionizer every three months.
1 Deinstall the ionizer.
2 Clean the insulation, white PTFE, around the emitter pin (1) and the emitter pin itself.
Note : Avoid touching this area with fingers to prevent contamination.
PTFE is white again.
3 Clean the insulation tube (3) between the steel emitter barrel (2) and the body of the ionizer.
4 Check that no ethyl alcohol is left on the ionizer.
See Installing Antistatic Kit (page 5).
Note
Please contact your METTLER TOLEDO representative for details of the available service options.
6.2 Disposal
In conformance with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE) this device may not be disposed of in domestic waste.
This also applies to countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at the collecting
point specified for electrical and electronic equipment. If you have any questions,
WARNING
Risk of electric shock
a) The ionizer must be disconnected from the power supply, before cleaning
or other maintenance work.
b) Use only the power cable from METTLER TOLEDO, if it needs replacing.
c) Ensure that no liquid comes into contact with the balance, the terminal,
the ionizer or the AC adapter.
d) Never open the balance, terminal, ionizer or AC adapter – they contain no
components which can be cleaned, repaired or replaced by the user.
e) Do not turn on power until the cleaned parts are dry.
1
3 2
Maintenance 9