Mettler Toledo Compact Antistatic Kit Mode D'emploi page 9

4.2.1 Installing Antistatic Kit
Balance is switched off.
Balance is disconnected from the power sup­
ply.
1 Remove the relevant side door (1).
2 Remove the any of the 3 clips, for example
the middle one (2).
– Push the compact ionizer in from back to
front until it clicks into place. If necessary,
gently squeeze the strips at the back.
1 Insert the side door (3) marked with "Con­
ducting Glass" (4) at an angle of approx.
30° into the two slots.
2 Lift the side door against the balance until it
clicks into place.
3 Push the side door completely to the front.
4 Check that the side door runs easily, other­
wise it is not correctly inserted.
5 For XPE balances, return the handle to the
upright position.
For XSE balances, clip the handle together.
1 Plug the power connection (5) into the socket
for AC adapter.
2 Plug the control cable (6) into Aux 1 or
Aux 2.
3 Plug the power supply cable (7) into the ion­
izer.
4 Connect the AC adapter (8) to the power sup­
ply.
1
2
3
4
6
8 7
Installation and Putting into Operation
5
5