NSK Ti-Max X-SG20L Mode D'emploi page 9

CAUTION
Do not connect or disconnect the handpiece until the motor has completely stopped.
Connect ONLY to E type motors (ISO 3964 (EN ISO 3964)).
Do not exceed the Max. Rotation Speed (Motor) shown in "10. Specifications".
X-SG20L / SG20
This handpiece is intended for use only with Surgical Units with Torque Calibration System such as NSK Surgic Pro. Using
this product with other surgical units may damage the handpiece or bone.
SG20
The handpiece is designed for connection to a NSK Non-optic motor or to a motor with a stopper pin. Connection to any
other type of motor cannot lock the handpiece.
5. Inserting and Removing the Bur/Drill
5-1 Inserting the Bur/Drill
7