NSK Ti-Max X-SG20L Mode D'emploi page 7

CAUTION
Do not exceed the bur/drill speed recommended by the bur/drill manufacturer.
Should the handpiece function abnormally during use, stop using the handpiece immediately and contact your Authorized
NSK Dealer.
Do not use the following fluids to wipe, immerse or clean the product; strong / super acid water, strong acid / alkaline
chemicals, chlorine-containing solutions, solvents such as benzine or thinner.
The handpiece is delivered in a non-sterile condition and must be autoclaved prior to use.
Perform regular function and maintenance checks. (Refer to "9. Periodical Maintenance Checks")
If the handpiece has not been used for a long period, rotate the handpiece and check for noise, vibration and overheating
before use.
To avoid clinical downtime it is recommended that a spare be kept on hand in case of a breakdown during treatment.
The operation of the handpiece is permitted only on dental units which correspond to the standards IEC 60601-1 (EN
60601-1) and IEC 60601-1-2 (EN 60601-1-2).
X-SG93L / X-SG93
Do not use a surgical bur with its maximum length of 25mm or longer. Using such bur with this handpiece may lead to
5
premature abrasion of the bearings. In addition, sudden release, bend or breakage of the bur may occur.