NSK Ti-Max X-SG20L Mode D'emploi page 16

8-1 Preparation
1) Wear eye protection, a mask and gloves to avoid infection.
2) Remove the bur/drill.
3) (Only for X-SG20L / SG20) Immerse about 20mm of the handpiece head in water,
and rotate the handpiece for about 15 seconds while switching the Forward/Reverse
rotation direction (Fig. 11)
4) Disconnect the handpiece from the motor.
8-2 Cleaning
Manual Cleaning (External Surface)
1) Remove debris on the handpiece surface using a brush under running water (at 38 C or less). Do NOT use a wire brush.
2) Wipe off moisture on the surface using an absorbent cloth.
CAUTION
If water enters the handpiece, using an air syringe, blow air into the rear of the handpiece to remove the internal water.
14
Fig. 11