Transport And Storage; Delivery; Intermediate Storage; Unpacking - Grundfos DMX 226 Notice D'installation Et De Fonctionnement

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 128

4. Transport and storage

Do not throw or drop the pump.
Store the pump in a dry and cool place.
Store the pump in upright position so that the gear
Caution
grease cannot leak out.
Do not use the protective packaging as transport
packaging.
Observe the permissible storage temperature!

4.1 Delivery

The DMX 226 dosing pumps are supplied in different packaging,
depending on pump type and the overall delivery. For transport
and intermediate storage, use the correct packaging to protect
the pump against damage.

4.2 Intermediate storage

Permissible storage temperature: -20 °C to +50 °C.
Permissible air humidity: max. relative humidity: 92 %
(non-condensing).

4.3 Unpacking

Retain the packaging for future storage or return, or dispose of
the packaging in accordance with local regulations.

4.4 Return

Return the pump in its original packaging or equivalent.
The pump must be thoroughly cleaned before it is returned or
stored. It is essential that there are no traces of toxic or
hazardous media remaining on the pump.
Grundfos accepts no liability for damage caused by
Caution
incorrect transportation or missing or unsuitable
packaging of the pump!
Before returning the pump to Grundfos for service, the safety
declaration at the end of these instructions must be filled in by
authorised personnel and attached to the pump in a visible
position.
If a pump has been used for a medium which is
Caution
injurious to health or toxic, the pump will be classified
as contaminated.
If Grundfos is requested to service the pump, it must be ensured
that the pump is free from substances that can be injurious to
health or toxic. If the pump has been used for such substances,
the pump must be cleaned before it is returned.
If proper cleaning is not possible, all relevant information about
the chemical must be provided.
If the above is not fulfilled, Grundfos can refuse to accept the
pump for service. Possible costs of returning the pump are paid
by the customer.
The safety declaration can be found at the end of these instructions.
The replacement of the supply cable must be carried
Caution
out by an authorised Grundfos service workshop.
17

Publicité

Table des Matières
loading

Table des Matières