4. Identification
4.1 Nameplate
The CUE can be identified by means of the nameplate.
An example is shown below.
T/C: CUE202P1M2T5E20H1BXCXXXSXXXXAXBXCXXXXDX
S/N: 123456G234
Prod. no: 12345678
1.5 kW (400V)
IN: 3x380-500 V 50/60Hz 3.7A
OUT: 3x0-Vin 0-100Hz 4.1 A 2.8 kVA
CHASSIS/IP20 Tamb. 45C/122F
IIIIIIIIIIIBAR CODEIIIIIIIIIII
Listed 76X1 E134261 Ind. Contr. Eq.
See manual for prefuse
CAUTION:
SEE MANUAL / VOIR MANUEL
WARNING:
STORED CHARGE DO NOT TOUCH UNTIL
4 MIN AFTER DISCONNECTION
CHARGE RESIDUELLE, ATTENDRE
4 MIN APRES DECONNEXION
Fig. 1
Example of nameplate
Text
Description
CUE (product name)
T/C:
202P1M2... (internal code)
Prod. no:
Product number: 12345678
Serial number: 123456G234
S/N:
The last three digits indicate the production date:
23 is the week, and 4 is the year 2004.
1.5 kW
Typical shaft power on the motor
Supply voltage, frequency and maximum input
IN:
current
Motor voltage, frequency and maximum output
OUT:
current. The maximum output frequency usually
depends on the pump type.
CHASSIS/
Enclosure class
IP20
Tamb.
Maximum ambient temperature
4.2 Packaging label
The CUE can also be identified by means of the label on the
packaging.
5. Mechanical installation
The individual CUE cabinet sizes are characterised by their
enclosures. The table in section 16.1 shows the relationship of
enclosure class and enclosure type.
5.1 Reception and storage
Check on receipt that the packaging is intact, and the unit is
complete. In case of damage during transport, contact the
transport company to complain.
Note that the CUE is delivered in a packaging which is not
suitable for outdoor storage.
5.2 Transportation and unpacking
The CUE must only be unpacked at the installation site to prevent
damage during the transport to the site.
Remove the cardboard box, and keep the CUE on the pallet as
long as possible.
The packaging contains accessory bag(s), documentation and
the unit itself.
MADE IN DENMARK
Note
Fig. 2
5.2.1 Lifting the CUE
Always lift the CUE using the lifting holes. Use a bar to avoid
bending the lifting holes. See fig. 3.
Fig. 3
The cardboard box has a drilling template for the
mounting holes. See fig. 2.
CUE packaging with drilling template
Recommended lifting method
7