Installation - Power Mount Tt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

INSTALLATION - POWER MOUNT TT HARDWARE

Attaching TT hardware to the seat frame tracks: Permobil, Quantum, Quickie, Rovi, & Avid Rehab.
All required tools are provided.
1
Loosen the screws (A), connecting the hardware mounting block (B) to the double nut(s) (C) using the 5mm hex key.
A gap between the mounting block and the double nut(s) is needed to slide into the seat frame track.
2
Attach the hardware mounting block (B) to the seat frame track by sliding the double nut(s) (C) inside of the seat
frame track. Some wheelchairs may require temporary removal of a cap at the end of the track for this step. Slide the
hardware to the general location on the seat frame track for the desired pad and hardware placement.
3 Do not fully tighten the screws (A). Continue with pad and hardware ADJUSTMENT and USE instructions in this manual.
PW1 - Quantum
PW2 - Permobil
PW3 - Quickie
PW4 - Rovi
PW5 - Avid
BodiLink Lateral Trunk Support Operation Manual
Track Slots
Note: For removable hardware, the release
lever can be installed towards the front or rear
of the wheelchair, pointing either up or down,
depending on user/caregiver preferences.
7
Permobil PW2 Mounting Block and
B
C
Removable Mounting
Bracket Shown
Release Lever
Seat Frame Track Shown
A