Adjustment - Power Mount Tt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

ADJUSTMENT - POWER MOUNT TT HARDWARE

Adjusting Power Mount TT Hardware.
W
= Width/Medial Adjustment
H = Height
1
Loosen the following screws:
H
Slider height set screws (each side of the post), using the 3mm hex key.
W Medial arm adjustment screw, using the 5mm hex key.
Note: If no medial positioning is needed, the medial arm can be removed and
the pad mount bracket can be fastened directly to the vertical slider post.
A
Pad swivel screw, using the 5mm hex key.
May need to be adjusted in combination with the above.
D Mounting block screws (if necessary), using the 5mm hex key.
H & D Pad mount screws (if necessary), using the 5/32" hex key.
2
Position the pad to the desired height, width location and transverse angle.
Note: The pad and/or medial adjustment arm should not compress the seat surface.
3
Fully tighten all screws that were loosened in step 1, using the appropriate hex key.
REMOVABLE HARDWARE: See "USE - GT HARDWARE" to change the release
lever orientation.
D
BodiLink Lateral Trunk Support Operation Manual
A = Angle
D
= Depth
H & D
14
A
W
H
Removable TT Hardware
Shown
Medial Arm Removal
Long
Screw
Short
Screw
Long
Screw