Use - Tt Hardware Release Lever; Use - Gt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

USE - TT HARDWARE RELEASE LEVER

Switching the removable TT hardware release lever orientation. Instructions apply to the power mount and the slot
mount. The lever location and orientation are subject to user/caregiver preference and ability to operate.
1 Firmly grasp the sides of the release lever base and pull straight out.
2
To re-install the hardware, insert the post (B) straight down into the mounting block receiver (C) until the post is fully
seated. Note: The release lever can be open or closed when inserting the post.
Power Mount TT
Hardware Shown
Note: To switch the location of the lever from the front to the rear of the mounting base/block, switch the left and right-hand side
hardware (or rotate 180° for power mount) during installation. Refer to the TT Hardware installation instructions in this manual

USE - GT HARDWARE

Using the removal feature on GT Hardware.
Slot Mount GT Hardware
WARNING: Hardware should be removed before transferring
into the wheelchair.
1
To remove the hardware from the mounting base, pull the
release lever (A) up (or down) until the lever remains in the open
position (~90°). Pull the hardware post (B) straight up and out of
the mounting base (C).
2
To re-install the hardware, insert the post (B) straight down into
the mounting base receiver until the hardware is fully seated.
Ensure that the release knob is fully retracted and the hardware
is engaged before use.
A
BodiLink Lateral Trunk Support Operation Manual
C
18
B
C