Use Tt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

USE TT HARDWARE

Removing and reinstalling TT hardware.
Power Mount TT Hardware
WARNING: Hardware should be removed before transferring into the
wheelchair.
1
To remove the hardware from the mounting block, pull the release
lever (A) up (or down) until the lever remains in the open position
(~90°). Pull the hardware post (B) straight up and out of mounting
block (C).
2 To re-install the hardware, insert the post (B) straight down into the
mounting block receiver (C) until the post is fully seated.
3
Once the hardware is fully inserted into the mounting block, ensure that
the release lever is fully closed and the hardware is engaged before use.
A
Slot Mount TT Hardware
WARNING: Hardware should be removed before transferring into the
wheelchair.
1
To remove the hardware from the mounting base, pull the release lever (A)
up (or down) until the lever remains in the open position (~90°). Pull the
hardware post (B) straight up and out of the mounting base (C).(or down)
until the lever remains in the open position (~90°). Pull the hardware
post (B) straight up and out of mounting block (C).
2
To re-install the hardware, insert the post (B) straight down into the
mounting base receiver (C) until the post is fully seated.
Note: Release lever can be open or closed when inserting the post.
3 Once the hardware is fully inserted into the mounting base, ensure that
the release lever is fully closed and the hardware is engaged before use.
A
BodiLink Lateral Trunk Support Operation Manual
17
B
C
C
B