Installation - Gt Slot Mount - Permobil BodiLink Lateral Pelvic Mode D'emploi

INSTALLATION - GT SLOT MOUNT HARDWARE
Attaching GT hardware to the Comfort Company solid seat support base. All required tools are provided.
1
Remove the screws (A), safety washers (B), flat
washers (C), double washer (D), and double nut (E)
from the GT hardware assembly (F) using the 5mm hex
key. Retain the fasteners for re-assembly.
2 Set the hardware assembly (F) on top of the seat support
base (G) in the desired location, making sure the slot in
assembly base (F) aligns with two of the slots on the seat
support base (G), as shown.
The screw heads (H) are intended to face forward on the
wheelchair for easier adjustments.
For removable hardware, the silver release knob (J) is
intended to face the front of the wheelchair for easier
access.
3
Replace the double nut (E) in the slot on (F).
4
Replace the screws (A), safety washers (B), flat
washers (C), and double washer (D) from below the
seat support base (G). Note: The squares on (D) should
fit into the slots on (G). Do not fully tighten screws to
allow further/final adjustments.
5
Continue with pad and hardware ADJUSTMENT and USE
instructions in this manual
Fixed GT Hardware Shown
BodiLink Lateral Trunk Support Operation Manual
E
F
D
C
E
A
10
H
B
A
D
C
B
J
G
F