Adjustment - Slot Mount Tt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

ADJUSTMENT - SLOT MOUNT TT HARDWARE

Adjusting Slot Mount TT Hardware mounted on a solid seat support base.
W
= Width/Medial Adjustment
H = Height
1 Loosen the following screws:
H Slider height set screws (each side of the post), using the 3mm hex key.
W
Medial arm adjustment screw using the 5mm hex key.
Note: If no medial positioning is needed, the medial arm can be removed and
the pad mount bracket fastened directly to the vertical slider post.
A Pad swivel screw, using the 5mm hex key.
May need to be adjusted in combination with the above.
H & D Pad mount screws (if necessary) using the 5/32" hex key.
W & D Base mount screws (if necessary) using the 5mm hex key.
Note: If the base mount needs to be repositioned towards the front or back
of the seat support base, the installation steps may need to be repeated. See
"INSTALLATION - SLOT MOUNT TT HARDWARE".
2
Position the pad to the desired height, width location and transverse angle.
Note: The pad and/or medial adjustment arm should not compress the seat surface.
3 Fully tighten all screws that were loosened in step 1, using the appropriate hex key.
REMOVABLE HARDWARE: See "USE - GT HARDWARE" to change the release
lever orientation.
W & D
BodiLink Lateral Trunk Support Operation Manual
A = Angle
D
= Depth
H & D
A
Fixed TT Hardware Shown
W
H
15
Medial Arm Removal
Long
Screw
Short
Screw
Long
Screw