Separately-Purchased Agility: Installation Of Direct Mount Hardware - Permobil ROHO Agility Max Mode D'emploi

Separately-Purchased AGILITY: Installation of Direct Mount Hardware

Warnings:
- DO NOT perform any tasks without first reading and understanding all of the safety information and provided instructions.
- DO NOT remove or install the AGILITY while the individual is seated in the wheelchair.
Except for the sliding height adjustment bar, none of the hardware provided with a separately-purchased AGILITY is
intended for use with Direct Mount Hardware. Follow the instructions carefully. Using the wrong components may
result in damage to the product and/or injury to the user.
1. Remove the AGILITY Cover.
2. Remove all AGILITY
hardware. Set aside
everything except the
sliding height adjustment
bar:
a. Remove and DO NOT
reuse. Store in a safe
location.
b. Remove and reuse the sliding height adjustment bar (x2)
with the Direct Mount Hardware. See below.
3. Attach the Direct Mount Hardware components and the
sliding height adjustment bar:
a. Place the 20mm Direct Mount Hardware
bolts in the sliding height adjustment
bar, leaving three open spaces between
the bolts.
b. On the back side of the AGILITY, place
the Direct Mount Hardware nylon
washers and star washers on the bolts.
c. Reattach the AGILITY Cover. Refer to the
ROHO AGILITY Back System Operation
Manual.
d. Place the Direct Mount Hardware onto
the AGILITY back shell and in the lowest
position. Make sure the AGILITY Cover
handle does not hang down. A bolt
should protrude through each opening
in the Direct Mount Hardware.
e. On both sides, attach the Direct Mount
Hardware washers and nylon-insert lock
nuts.
6. See the instructions in this manual for installation on the
wheelchair.
ROHO AGILITY Direct Mount Hardware Operation Manual
A B C D
AGILITY lock nut (x4) A
AGILITY adjustment plate (x2) B
AGILITY star washer (x4) C
25mm AGILITY bolt (x4) D
2a
3a
3b
9
2b
3c
3d
3e