Adjustment - Slot Mount Gt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

ADJUSTMENT - SLOT MOUNT GT HARDWARE

Adjusting Slot Mount GT Hardware mounted on a solid seat support base.
W
= Width/Medial Adjustment
H = Height
1 Loosen the following screws:
W & H Link joint screw(s), using the 5mm hex key.
Note: Link joints are "spring-loaded". Loosen the screws enough to allow a
smooth ratcheting adjustment.
A
Pad swivel screw, using 5mm hex key.
H & D Pad mount screws (if necessary) using the 5/32" hex key.
W & D Base mount screws (if necessary), using the 5mm hex key.
Note: If the base mount needs to be repositioned towards the front or
back of the seat support base, the installation steps may need to be
repeated. See "INSTALLATION - GT SLOT MOUNT".
2 Position the pad to the desired height, width location and angle.
Note: Pad and/or medial adjustment arm should not compress the seat surface.
3
Fully tighten all screws that were loosened in step 1, using the appropriate
hex key.
WARNING: Make sure that the teeth on all link joints are properly aligned
and engaged before final tightening. Failing to do so could cause wear on the
teeth, leading to parts slipping out of adjustment or hardware failure. (GT
Hardware only)
*Gear Teeth Alignment
Note that some adjustments may be affected by
each other and require compensation before final
tightening.
Height with No Link
Adjustment
BodiLink Lateral Trunk Support Operation Manual
A = Angle
D
= Depth
Height after Link
Width Adjustment
W & H
W & D
16
H & D
A