INSTALLATION - EXTENSION ARM TT HARDWARE
For adding long extension arm to TT hardware. Required tools are shipped with TT mounting hardware.
1
Using the 5mm hex key, remove the long screw (A) and short screw (B) with safety washers (C) from both ends of
standard arm (D), included with the TT hardware assembly. Retain the fasteners for re-assembly.
2
Align the long extension arm (E) with the top of the hardware assembly (F), and replace the screw (B) and safety
washer (C) in the orientation shown.
3
Align the other end of the long extension arm (E) with the mounting bracket (G), and replace the screw (A) and safety
washer (C).
4
Continue with pad and hardware ADJUSTMENT and USE instructions in this manual.
A
C
D
BodiLink Lateral Trunk Support Operation Manual
A
C
B
C
G
9
F
E
B
C