Installation - Extra Link(S) To Gt Hardware - Permobil BodiLink Lateral Pelvic Mode D'emploi

INSTALLATION - EXTRA LINK(S) TO GT HARDWARE

For adding extra hardware link(s) to GT hardware. All required tools are shipped with GT mounting hardware.
WARNING: Adding additional links to the hardware may reduce the overall strength.
WARNING: Make sure that the teeth on all link joints are properly
aligned and engaged before final tightening. Failing to do so could cause wear
on the teeth, leading to parts slipping out of adjustment or hardware failure.
(GT Hardware only)
1
Remove the screw (A), safety washer (B), and spring (C) from the hardware joint using the 5mm hex key. Retain the
screw, washer and spring for the additional link.
Suggestion: If adding multiple links to one assembly, first line up the extra links and fasten with the screws, washers and springs
provided to create one extra link assembly.
2 Line up the extra link(s) (E) with link (D) and fasten with screw (F), washer (G), and spring (H) included with the extra link.
3
Line up the extra link(s) (E) with link (J) and fasten with screw (A), washer (B), and spring (C) that were retained in step 1.
4
Continue with pad and hardware ADJUSTMENT and USE instructions in this manual.
C
B
A
BodiLink Lateral Trunk Support Operation Manual
F
Fixed GT Hardware Shown
11
*Gear Teeth Alignment
H
G
C
B
A
D
E
J