Adjustment - Basic Pad - Permobil BodiLink Lateral Pelvic Mode D'emploi

ADJUSTMENT - BASIC SUPPORT PAD
Adjusting the basic support pad with TT or GT hardware.
Recommendation: If one hardware assembly is being used per pad, install the hardware closer to the center of the pad (depth). If
two hardware assemblies are being assembled onto one pad, install one hardware assembly towards the front and one towards
the back (depth).
1
To adjust the pad height relative to the mounting hardware, loosen (but do not remove) the pad mounting screws (A)
using the 5/32" hex key, and then slide the pad to the desired height position, and fully tighten the screws, using the
hex key.
A
1
To adjust the position of the pad depth
relative to the mounting hardware, remove
the pad mount screws (A) and safety
washers (B) using the 5/32" hex key. Retain
the fasteners.
2
Move the pad to desired position, lining up
with the new set of T-nuts. Reassemble the
fasteners, using the hex key.
BodiLink Lateral Trunk Support Operation Manual
Fixed Slot Mount TT
Positioning for the depth of the pad.
13
Hardware Shown
B
A