INSTALLATION - BASIC PAD TO MOUNTING HARDWARE
For any Basic pad and TT or GT hardware styles. All required tools are provided.
In some cases, the pad will come installed on the hardware. Each pad will have a series of T-nuts for hardware mounting.
The T-nuts are accessible through the slits in the cover (not pictured) for easy hardware mounting/removal.
1
Line up the screws (A), safety washers (B), and slots on the mounting bracket (C) with the desired T-nuts on pad (D).
Recommendation: If one hardware assembly is being used per pad, install the hardware closer to the center of the pad (depth).
If two hardware assemblies are being assembled onto one pad, install one hardware assembly towards the front and one
towards the rear of the pad.
2
Tighten the pad mount screws (A) using the 5/32" hex key.
Note: Do not fully tighten the screws if you are expecting to make further pad height adjustments while installing on the
wheelchair.
Zero Elevation Shape Pad and
Slot Mount TT Hardware Shown
Anti-Thrust Shape Pad with
multiple sets of TT Hardware Shown
BodiLink Lateral Trunk Support Operation Manual
D
C
6
B
A