Pad Installation; Important - Permobil BodiLink Manuel D'utilisation

PAD INSTALLATION

Installing the Pad on the Mounting Hardware. All required tools are provided.
IMPORTANT: The cover has mounting screw holes, which should be used to keep the cover attached to the pad during
use. During pad installation, the screws should go through the holes in the mounting bracket, the cover, and the pad.
Note: The pad may already be installed on the hardware.
1
Line up the screws (A), the safety washers (B), and the slots on the mounting bracket (C)
with the holes (D) in the cover and the pad.
Notes: The seam of the foam and the seam on the cover should face away from the user. For
Oval Pads and Wedge Pads, the narrow end of the foam core should face the user.
2
Tighten the screws (A), using the 5mm hex key.
Note: Do not fully tighten the screws if you expect to adjust the pad depth while installing the
equipment on the wheelchair.
The screws (A) should go through the
holes in the bracket, the mounting screw
holes in the cover*, and holes in the pad.
*Cover not shown.
BodiLink Medial Knee/Thigh Support Operation Manual
B
A
Small Hardware with
2.5" x 3.5" (6.4cm x 8.9cm) Wedge Pad
D
C
6