Disposal - Trotec TTR 2000 Mode D'emploi

Disposal

The icon with the crossed-out waste bin on waste
electrical or electronic equipment stipulates that this equipment
must not be disposed of with the household waste at the end of
its life. You will find collection points for free return of waste
electrical and electronic equipment in your vicinity. The
addresses can be obtained from your municipality or local
administration. For further return options provided by us please
refer to our website www.trotec24.com.
The separate collection of waste electrical and electronic
equipment aims to enable the re-use, recycling and other forms
of recovery of waste equipment as well as to prevent negative
effects for the environment and human health caused by the
disposal of hazardous substances potentially contained in the
equipment.
The information regarding proper disposal of the desiccant
dehumidifier is based on the current status of May 2017.
The disposal regulations are likely to have changed by the time
of disposal. Therefore you have to inform yourself of the current
disposal regulations and take changes into account.
You are responsible for deleting any personal data stored on the
waste equipment to be disposed of.
Warning
Potential environmental hazard due to incorrect
disposal.
Failure to follow the rules on disposal or an improper
disposal of contaminated air filters can lead to
environmental hazards.
In order to carry out the disposal professionally, you
have to be a qualified specialist.
Recycle empty batteries.
Observe the currently applicable regional and, as the
case may be, national disposal regulations.
Supplies
1. Shut down the desiccant dehumidifier definitely.
2. Disconnect the desiccant dehumidifier definitely from any
supplies (current, water etc.).
3. Remove any supplies such as air filters, oils, coolant,
batteries etc.
4. Dispose of these supplies separately according to the
applicable regulations.
EN
Components of the desiccant dehumidifier
The desiccant dehumidifier is composed of the following
disposable materials:
• Steel, sheet steel, hardened steel, e.g. screws, motor
shafts, component parts
• Different types of plastic, e.g. installation material,
insulation material, window
• Rubber parts, e.g. seals and feet
• Plastic hoses
• Power cables, electric lines, electrical devices such as
motors, controls, electronic components, electrical control
elements, installation material, sensors
Final disassembly
For disassembly of the desiccant dehumidifier please proceed
as follows:
1. Carefully disassemble the assemblies and parts that you
want to continue to use in order to avoid damage to these
parts.
2. Take notes so that you can re-assemble the used parts
correctly.
3. Provide appropriate temporary storage facilities to be able
to store the amounts of different materials separately.
4. Use the specified fastening elements for disassembly:
Remove the specified fastening elements to separate the
parts from one another.
5. If possible, do not use any angle grinders or welding
equipment as this would cause unnecessary additional
effort.
6. Always work in pairs when disassembling large parts.
7. After disassembly has been completed, have the parts
collected by a qualified disposal company.
8. Store parts to be used again.
Return to manufacturer
The desiccant dehumidifier does not comprise any components
that are intended to be returned to the manufacturer.
Notification of authorities and manufacturer
An official deregistration of the desiccant dehumidifier is not
required. This could, however, change if the disposal
regulations are amended. Make sure to dispose of the desiccant
dehumidifier correctly.
Should you be unable to dispose of the device properly, please
contact the manufacturer and instruct him to carry out the
disposal on your behalf.
desiccant dehumidifier TTR 2000 / TTR 2800 / TTR 3700 22