Bosch BPT-S 3 Manuel De Service page 226

108 | Help in the event of faults
Fault message
ENGLISH
DC OVERVOLTAGE
Bosch BPT-S 3 / 3.68 / 4 / 4.6 | Operating manual
LED status indicator
All LEDs are flashing
red
Possible cause
Overvoltage
English
Possible fault
rectification
– Do not touch the
device
– Switch off the AC fuse
– If DC circuit breaker is
available within the
installation, set the
DC circuit breaker to
0 (=off).
– Contact Bosch Power
Tec Service (see
contact details on the
back of the manual)
Bosch Power Tec GmbH