Bosch BPT-S 3 Manuel De Service page 156

38 | Transportation and installation
NOTICE
NOTICE
Bosch BPT-S 3 / 3.68 / 4 / 4.6 | Operating manual
Material damage caused by condensation
If the device is moved from a warm, damp
environment to a cold installation location,
condensation may form inside the device.
In the reverse case: If the device is moved from a cold
environment to a warm installation location,
condensation can form on the housing (especially on
the heat sink).
When connecting to a voltage supply, condensation
on electronic components can cause a short circuit
and damage to the electronics.
Before commissioning, the device must be

completely de-energised and acclimatised for at
least 2 hours.
Material damage due to inadequate ventilation
If, due to an inadequate or blocked air supply, the
device is not cooled sufficiently, this can cause the
device to age prematurely and, therefore, lead to
irreversible damage.
Ensure that there is sufficient ventilation

Mount the device vertically

Observe the minimum clearances

Do not install any equipment which generates warm

exhaust air above or below the device or which
blocks the air supply
Do not mount devices on top of each other

Do not store any objects on or above the device

Do not cover the front panel of the device

When mounting the device in a control cabinet,

make sure there is sufficient air circulation and the
required ambient temperature
English
Bosch Power Tec GmbH