Gesture Control - Bosch BPT-S 3 Manuel De Service

22 | Technical description English
Using e.Data
The third option: The string inverter can be
connected to a local network via an Ethernet
connection. Using a standard internet browser, the
installer can enter the serial number in the address
line of the browser, gaining direct access to the menu
of the string inverter.
The integrated e.Data setup tool can be called up via
the menu. The installer can also set the specific
parameters for a country using e.Data.
In addition, the installer can use e.Data to read all of
the data saved by the string inverter, including fault
messages.
Information on commissioning using e.Data can be
found in chapter Starting up the string inverter using
e.Data, p. 89.
3.2.3

Gesture control

The Bosch BPT-S series string inverters are fitted
with a contactless sensor for navigating the device
menu. If the installer approaches the device, the
operation menu automatically switches on. It is now
possible to scroll through and make settings in the
operating menu using gesture control. Gesture
control is characterised by the fact that the device
can continue to be operated under difficult
conditions.
In addition, the Bosch BPT-S series string inverters
are equipped with a two-line display and a circle of
status LEDs.
As an alternative to the e.Key or e.Data, once the start
screen has appeared, the string inverter can be
activated using gesture control.
Bosch BPT-S 3 / 3.68 / 4 / 4.6 | Operating manual Bosch Power Tec GmbH