Kalorik PRO KPRO FT 42777 SS Manuel D'utilisation page 20

WARNING:
Always turn the unit off, disconnect the plug from the wall outlet
‒
and then the magnetic plug from the control panel assembly
before cleaning. Allow all parts of the appliance to cool down
completely.
NOTE:
Do not immerse the power cord with plug, magnetic plug or
‒
appliance into water or any other liquids. Do not use abrasive
cleaners, steel wool or scouring pads. Dry all parts thoroughly
after cleaning, before using or storing the appliance. Ensure
that no water enters the appliance housing.
Do not attempt to attach the magnetic plug permanently to
‒
the appliance.
• Ensure the oil container is in place, then turn the oil filtration control
knob to FILTER OIL position to empty the oil reservoir (see Oil
filtration).
• Place the basket on a clean, flat and heat resistant surface.
Danger of burns!
Ensure the basket cooled down completely before touching its
‒
surface and attempting to remove the basket handle.
Ensure the oil cooled down completely before emptying the oil
‒
reservoir into the oil container.
• Remove the basket handle from the basket.
• Remove the control panel assembly from the oil reservoir. Carefully
clean the control panel assembly and immersion heater with a
damp cloth.
• Pull the oil filter cover from the oil reservoir and then remove the oil
reservoir from the housing.
• Open the lid filter cover and remove both black and white filters.
• Clean the appliance housing with a damp cloth.
• Wash the lid, basket, basket handle, oil reservoir and oil filter cover
with hot soapy water or in a dishwasher. Rinse and dry carefully.
• Dry all parts thoroughly after cleaning and before using the
appliance again.
WWW.KALORIK.COM
20
KPRO FT 42777 – 200605