Sony VPH-G90E Manuel D'installation page 90

Adjusting the Magnetic Focus
6 2
1
4
7
3
2 Adjusting the red magnetic focus, AQP/DQP and AHP/DHP
90
(GB) Adjustments
5
Press the POSITION + key once to enter the focus adjustment mode
8
for the upper parts (position No. 2).
When you press the POSITION + key, the part to be adjusted cycles
5
through the order as illustrated on the left. The position number is
displayed at the upper right corner.
If you press the POSITION – key, the part cycles through the reverse
9
order.
F O C U S A D J
- G - M G - A L L
M G : [ 1 2 8 ]
A Q P : 1 2 8
D Q P : 1 2 8
A H P : 1 2 8
D H P : 1 2 8
6
Adjust the AQP, DQP, AHP and DHP for position No. 2.
Press the v or V key to select the adjustment item and press the B or b
key to correct the distortion of the spot.
7
Press the POSITION + or – key to select the adjustment position and
repeat steps 5 and 6 for each position.
Adjust positions No.3 to No.9 in order.
8
Press the FUNCTION key once to exit from the SPOT SHAPE mode.
9
Display the ME-pattern with the PATTERN key.
10
Press the POSITION + or – key to select the adjustment position No. 2
to No. 9 and adjust MG, AQP and DQP so that the letters ME are
clearly visible for every part of the screen.
Note
Do not adjust AHP and DHP for positions No. 2 to No. 9.
11
Press the CUT OFF G and B keys to display the red signal only, and
adjust AQP, DQP, AHP and DHP in the same manner as the green
signal.
12
Press the CUT OFF G and R keys to display the blue signal only, and
adjust AQP, DQP, AHP and DHP in the same manner as the green
signal.
Press the CUT OFF G and B keys to display the red signal only. Then
adjust the red magnetic focus, AQP/DQP and AHP/DHP. To adjust them,
perform the same procedure as for the green signal.
For details, see "1 Adjusting the green magnetic focus, AQP/DQP and AHP/
DHP" on pages 87
(GB)
P O S I T I O N
N o . 2
SEL: ADJ:
+ –
NEXT:
to 90 .
(GB)